Technical Requirements For Backstops

Sep 18, 2026

Leave a message

Key Design Parameters
The rotation direction of the backstop's inner race is classified as either clockwise (S) or counter-clockwise (N). The operating ambient temperature typically ranges from –20°C to +60°C.

 

New Design Developments
The non-contact sprag backstop featuring a logarithmic spiral profile represents a new design. The sprag design parameters (such as initial polar radius and involute coefficient) influence backstopping performance and load distribution; this design offers advantages such as uniform wedging force, even wear, smooth backstopping action, and extended service life.

 

Technical Requirements for Practical Application
High precision is required for installation alignment, with axial deviation controlled to within 0.05 mm. Operation exceeding rated torque is strictly prohibited. Lubrication status must be checked regularly, and the unit must be matched to the motor's start-stop frequency. High-quality alloy steel subjected to heat treatment is used, achieving a sprag surface hardness of HRC 58–62.

Send Inquiry